46mm Coilovers Remote Reservoir Mounting Bracket

Descripción

This innovative 3D-printed coilover reservoir mounting bracket, designed for automotive enthusiasts seeking enhanced performance and customization. This lightweight yet sturdy bracket offers a perfect fit for a variety of coilover setups, ensuring optimal positioning of your reservoirs for improved fluid dynamics and easier access. With 3D printing, the bracket not only reduces weight but also adds a sleek, modern touch to your suspension system. Elevate your ride’s performance and aesthetics with this precision-engineered solution, tailored for those who demand the best in their automotive builds. Additional Hardware will be required. Four - m4 x 8mm hex cap bolts https://tinyurl.com/2te4ex3s Four - m4 x 4mm heat nut inserts https://tinyurl.com/3s4d27hw Two - m6 x 10mm hex cap bolts https://tinyurl.com/3rfvcsnk Two - m6 rubber well nuts https://tinyurl.com/3arz6xc3 Roll of 5mm foam tape (optional, only use if the reservoir is moving freely inside the bracket) https://tinyurl.com/55bkhym4 Instruction: 1) Press the m4 heat nut insert into the lower bracket with a solder iron 2) Take the lower bracket to your desired mounting location and mark the 2 m6 bolt holes. 3) Center punch your marks and drill two 14mm holes. Insert the rubber well nuts 4) Mount the lower bracket with two m6 x 10mm bolts 5) Mount the top bracket with the lower bracket with four m4 x 8mm bolts