Adderini/Miniadder front grip advanced

Descripción

This modified model serves to eliminate possible printing or stability problems, as on the one hand the handle is very complex to print and on the other hand the handle has a considerable weak point at one point. This makes it possible to print a more stable handle and/or a replacement after a breakage in advance. It also saves time-consuming and larger replacement prints. The only thing necessary is: -a soldering iron with soldering attachment if necessary -An Allen screwdriver the following material to supplement the modification: -M3 x 10 Allen screws (2 pcs.) -M3 x 5 x 5 threaded insert (2 pcs.) Feed-through: 1) Print the lower handle on the flat side, but print the upper part, which could also be called the weak point, upright with support, so that the weak points are supported! 2) Insert the threaded inserts vertically and flush with the edge. Not deeper than the edge! 3) Screw together and tighten lightly. Then follow the instructions from Lukas.