Arrma Mojave Grom skid plate

Descripción

Instructions for installation: 1. Remove 4 screws of the original skid plate 2. Use a lighter to heat 3mm above the front screws 3. Slightly bend the heated area to match the profile of the bumper 4. Place the skid plate on top of the original 5. Screw in the skid plate with the original 4 screws You can also heat up the joins then place the skid plate on the car and bend it to the shape of the chassis *UPDATE* For the rear skid plate, you must bend both sides to follow the form of the chassis Notes from creator: Skid plate is made flat so no support is needed at all. Also it will be stronger since printing it to fit the chassis directly will make it easy to break. I also tried to make this as thin as possible while also protecting the screws since the Mojave Grom already has low clearance. Making the clearance lower would just make the car harder to drive.