AT-1 RC Drift chassis 1:10

Descripción

This chassis, AT-1, is engineered to accommodate both short and standard 2S LiPo batteries, with the ability to mount batteries in both high and low positions. Furthermore, three motor mounting positions provide additional customization options, allowing you to tailor the chassis to your specific driving style. The chassis also has active rear toe, which enhances control and stability during high-speed drift. It uses a reliable belt drive system that is designed to use commonly available Sakura 38T belt diff and 44mm CVD shafts which are commonly used in 1:10 cars. Adjustable camber, rear toe, front toe, caster. I have included a set of wheels and tyres in the file to get you started but I would recommend getting actual drift tyres to suit your drift surfaces, together with quality drift gyro and servos to truly enjoy RC drifting. I have also added a set of suspension arms that uses 3x6x2.5 (MR63) bearings to minimize slop in the suspension arms. You will need 12 bearings for the whole car. Wheelbase: 257 (Adjustable +/- 5mm) Designed to fit standard 1:10 body shells Parts list: S3M 192 belt (3mm wide) x1 Sakura 38T belt diff x1 Front axle x2 for YD-2/ RDX/ RD2 or similar 4.8mm M3 ball head x 26 44mm CVD drive shaft x 2 MR85 bearing x 8 MR63 bearing x 2 MR105 bearing x 8 MR6700 bearing x 2 (for belt diff) MR6701 bearing x 2 MR128 bearing x2 M3x45mm pin x6 Screws (Rough estimate, changes depends on your set up) M3x8 CS x64 M3x12 CS x16 M3x18 CS x2 M3x8 BH x 8 M3x10 BH x5 M3x12 BH x4 M3x14 BH x12 M3x25 BH x2 M3 Nut x2 M3x4 set screw x2 M3x16 set screw x6 Turnbuckles 3x18 (x2) Toe link 3x23 (x4) Front steering link and rear camber link 3x32 (x1) Servo steering link