Element Bushido Interior

Descripción

This interior fits the Element RC: Bushido It takes 35 hours to produce a complete interior. The interior is designed for the stock Bushido configuration (SHORT BATERY TRAY). The hand break and shifter boot have a hole in the top for and M3 Screw. The idea is to use a Ball stud or screw to complete the look of the handle. Hardware needed: 2 - M2x5x8, 2 - M3x8, Glue. Paint To install: The rear of the Top Plate will mount to the rear screws for the stock role cage in the bed. The front of the Top plate will mount to the underside of the hood with either glue or the hood vent with two screws through the body. All other parts will be secured to the top plate for installation. Optional Cage Note: The underside of the top plate and the back of the dash have registration marks for you to drill the needed holes to screw the optional cage to the dash and top plate. If you don't want the cage, there will be no holes to muddy up the look. Dash Note: The holes in the side of the dash will capture the posts of the side mirrors. Make sure the D of the body clip is facing the front of the truck for clearance. It is possible to use only the dash mounted to the mirrors and tacked in place with some hot glue. this option is nice for those who want to make a light weight interior out of other materials and not want the weight of the 3D Printed Tub. The body with all interior components installed will weigh about 1lb 3 oz. You may need a heaver spring weight to compensate for the added "realistic" weight.