Evolution chassis 1/10 DKS Basic from DukeDoks

Descripción

Hello everyone, Having downloaded and printed the RC car chassis from DukeDoks, I realized that nothing was provided to hold the receiver and controller. So I modified the front part of the chassis in a very simple way, so that I could pass a scratch strap through to hold them, just as the original designer did for the battery. Nothing exceptional, just small bridges (printed without support) that allow three straps to pass through in total. Link to the original chassis created by DukeDoks : https://cults3d.com/en/3d-model/game/casis-1-10-adaptable I also recommend an evolution I found on this site, to switch to belt drives instead of printed gears, which wear out more than quickly: https://cults3d.com/en/3d-model/game/belt-drive-conversion-for-1-10-adaptable-chassis-w-optional-cooling-fan