Fan mount for RC motor

Descripción

This is a great and cheap banggood motor. The fins allow for a great cooling potencial, however inside the chasis there is likely little airflow, and my motor after a 1.5A 2S lipo would get a bit hot. Since it is more than capable of 3S, I wanted to add some cooling to it. Designed this duct, gave it a shot and after bashing the whole LiPo the motor was way cooler, this is printed in PETG and any settings should be fine. It "clicks" into the motor wonderfully :D (I had a 5v 40mm fan that plugged straight into the receiver)