LEGO Technic Bugatti Chiron (42083) – Wall Mount + Speed Key Mount – 3D Printed

Descripción

LEGO Technic Bugatti Chiron (42083) – Wall Mount Display Stand 🏎️✨ Turn your LEGO Technic Bugatti Chiron (42083) into a stunning wall-mounted display piece! This 3D printed wall mount lets you showcase your model in a stylish, secure and space-saving way — no more leaving it on a shelf. 🎁 Bonus included: a dedicated wall mount for the Bugatti Speed Key is also included in the files! ________________________________________ 🧩 How it works The mount attaches firmly to the wall with a screw. Your car is safely held by its chassis — the strongest part of the build. Installation is quick and easy so you can display or remove your set whenever you like. • Print the PDF template at 100% scale and tape it to the wall • Mark and drill the holes using the template • Screw the mount to the wall • Place your Bugatti Chiron on the mount No tools needed beyond a screwdriver. ________________________________________ 🔧 Optional hook reinforcement — highly recommended The wall mount features a built-in threaded socket designed to accept an optional Ø3 mm × 30 mm countersunk screw. When inserted, the tip of this screw internally reinforces the hook — completely invisible from the outside. This reinforcement is optional, but strongly recommended. A few users have broken the hook by handling the car incorrectly or hanging it at the wrong point. Adding this screw takes 10 seconds and makes the mount virtually indestructible. • Without the reinforcement screw: the hook holds perfectly under normal use • With the reinforcement screw: maximum strength, zero risk ________________________________________ 📐 Dimensions • Car mount: 5.4 × 2 × 3.4 cm ________________________________________ 🖨️ Recommended print settings • Material: PLA, PETG, ABS, ASA... your choice! • Infill: 25% minimum • Layer height: 0.15 mm • Supports: required (small support needed under the hook return) • Perimeters: 3 minimum for good strength ________________________________________ 📦 Files included (3 files) • Bugatti_Chiron_42083_Wall_Mount.stl – wall mount for the car • Bugatti_Chiron_42083_Speed_Key_Mount.stl – wall mount for the Bugatti Speed Key • Bugatti_Chiron_42083_Template.pdf – printable paper template to mark exact drilling positions 💡 Print the PDF template at 100% scale (no scaling), tape it to the wall, mark the holes, drill — done! ________________________________________ 🔩 Hardware not included Car mount: recommended countersunk head screw Ø3 mm × 50 mm + Ø5 × 25 mm wall anchor. Speed Key mount: recommended countersunk head screw Ø3 mm × 30 mm + Ø5 × 25 mm wall anchor. Optional hook reinforcement: countersunk head screw Ø3 mm × 30 mm (screwed directly into the mount — no anchor needed). All available at any hardware store. ________________________________________ 💡 Tips • Print the PDF template at 100% scale — tape it to the wall, mark the holes, remove it, then drill. Easy and perfectly aligned every time. • Always hang the car by its chassis — never by the body panels. • PETG gives slightly better long-term rigidity if your model is displayed in a warm room. ⚠️ LEGO® Technic Bugatti Chiron set (42083) is not included. This is a compatible accessory, not affiliated with LEGO® or Bugatti®. ________________________________________ ⭐ Enjoying this design? A like or a short review goes a long way to help this design get discovered by other makers. Thank you so much! 🙏 Designed and tested in Nancy, France 🇫🇷