Mazda S3/Fb Rx7 Front Lip/Airdam

Descripción

This is my original design of a Front Lip for the Series 3 (84 - 85) Mazda Rx7. I believe it should be compatible with Series 2 cars assuming the mounts are the same for the front lip, but i cant guarantee they are. This is not compatible with pre-facelift Series 1 cars. Once printed & assembled this model will bolt right on with OEM+ fitment (lower clips aren't installed in my photos causing the visible defect) . In theory the plastic part could be ran on the car but I haven't tested it as I'm using it to make a mould for a composite part. i made mine on a 400mm3 Ender 5 max but the model is split so it should fit on a standard 200mm2 build plate with a max Z of 300mm