Mehari door striker / latch (old model)

Descripción

Replacement part for Mehari door striker / latch (old model) ref. no. 0440400. Works fine in plastic. This version is in PET, but I think PLA or any other material works. Medium to high infill recommended. Also recommended to use 0.2mm layers or less, as the striker slope will be less jagged. Print with door-mounted side down, requires the least amount amount of support and gives the nicest finish. Been a while since I've modeled and tested this part, but it has been on the car for eight years now without issues. For spacing plates, see: https://www.thingiverse.com/thing:5702972