Original All Audi Front Grille Logo

Descripción

Compatible with 3D printing (Bambu Lab P1S / P1P / A1 Combo). 🔧 Recommended 3D Printing Settings Material: ABS or ASA (recommended for automotive use) Infill: 30% Gyroid Infill Density: 12% Layer Height: 0.16 mm Layer Width: 0.6 mm Nozzle: 0.6 mm Bed Temperature: 100–110°C Nozzle Temperature: 240–260°C Cooling Fan: Off or very low Supports: Not required (depending on model design) ℹ️ Notes Designed for front grille installation. Suitable for exterior automotive use. High temperature resistance when printed with ABS/ASA. This is a replacement part, not an original manufacturer product.