RC Car Test Ramp / RC Car Test Ramp

Descripción

I have designed a ramp so you can test your RC car, to know what % of slope is able to overcome. It has been specially designed for the Jeep Orlandoo Hunter model that is 1/35 scale but you can scale the design and adapt it to your model, that you can do with the Cura laminator, etc. Keep in mind that you must climb the same percentage x, y, z to keep the slopes. The "A, B VERTICAL" pieces have the percentage of slope in relief. The sections are: 10%, 20, 30, 40, 40, 50, 50, 60, 70, 80, 100, 120 and 150%. I hope you enjoy it. Instructions: Print 2x A Vertical, 2x B Vertical. and they are placed crossed on the "FOOR" (See the instructions in the photos) Link Orlandoo Hunter: https://s.click.aliexpress.com/e/_DCvoazl Video... https://youtu.be/Co8Qg-m01GY Video Instructions... https://youtu.be/X3QJuwpS_Rk "Flex_Union" is an optional part if you want to print it in flexible filament and attach it with electrical tape to the "Ramp" part. In the "Floor" part I include a table with the relation between% slope and degrees English: I have designed a test ramp where you can test your RC car. It is specially designed for 1/35 scale cars and similar like , for example, the Orlandoo Hunter Jeep but you can scale it to other sizes. As you know you can do that with a simple laminator like Cura or another program. Note that to respect the slopes you have to vary the x,y,z proportions in the same proportion. I hope you enjoy it. Instructions: Print 2x "A Vertical" 2x " B Vertical" and place them crosswise on the "FLOOR" piece ( See the instructions in the pictures). "Flex_Union" is an optional part, if you want you can print it in flexible filament and attach it with insulating tape to the "Ramp" part. in the "Floor" part I include a table with the equivalence between % slope and degrees.