Stinger Buggy (SCX24)

Descripción

Here is my ultimate SCX24 Buggy design. It took be about 6 months and 10 different iterations to finally get it to where I wanted. This design is best when printed using Hatchbox ABS. This allows for a better impact resistance while still retaining good overall strength. The Stinger Buggy is designed to use the following Axial SCX24 parts. - Stock Axles - Jeep rear 4 links & Driveshaft on front - Deadbolt rear 4 links & Driveshaft on back - Skidplate - Transmission - ESC - Steering (Links and Servo) - Battery Strap Recommended aftermarket parts: - Wheels/Tires (I used Mud Slingers & RC4WD Stamped Steel wheels, mounted backwards.) - Double-Barrel shocks - Surpass Brushless Motor (C2204 - 1400kV) **Note: I did add room for the C2216 1120KV Surpass motor) - Hobbywing 18A Brushless Controller (Connected to Ch2 on ESC) - 3s Lipo battery - EMAX steering servo - Lots of brass stuff on the axles Note: When mounting a Surpass motor, you will also need my Surpass motor mount that will be included with the chassis. It will also be available separately.