Super Easy RC Boat

Descripción

I designed this boat to be super easy to print and very cheap to build. Minimum build plate: 235mm by 90mm by 50mm (I used my very old, and untuned Ender 3, and I had no problems) Build Instructions: Step 1:Glue the front and the back of the boat together (Hot glue works best), making sure it makes a good seal with no holes. Step 2: Apply glue to the tops of the motors and slide them into their slots on the back of the boat, making sure they are perfectly straight. Step 3: Make a waterproof seal with glue between the sides of the motors and the boat. Step 4: Ensure that both motors spin in opposite directions to prevent torque twist, and print one left prop and one right prop. Step 5: Put on the propellers and finish up the electronics, making sure to put the heaviest items in the middle/back of the boat. Electronics: This is the best option for most performance ---> (https://www.aliexpress.us/item/3256807855733430.html?src=google&gatewayAdapt=glo2usa)- or using the electronics out of a cheap RC car works as well.