Tamiya Mini 4WD Chassis for RC conversion

Descripción

This is a bespoke chassis to convert your Tamiya Mini 4WD car into Radio Control. It uses common parts such as your standard Tamiya mini 4wd gears (28T brown gears, pink/orange crown gears, 8T pinions) and standard 130-size motors. Full Parts List: =========== 84mm hex shafts x 4 required (cut down accordingly to make 2 pieces of 80mm for the prop shafts, 2 pieces of 31.5mm for the rear wheel shafts and 2 pieces of 24.5mm for the front wheel shafts) https://m.id.aliexpress.com/item/1005002523909672.html 2mm inner diameter PVC tubing required (Cut 4 pieces, each 1.5mm long to make end stops for the wheel shafts) https://m.de.aliexpress.com/item/4000261662779.html 8T copper x 4 , nylon pinions x 2 required https://m.de.aliexpress.com/item/4000471025824.html 130 size Original Mabuchi motor x 2 required https://m.de.aliexpress.com/item/32973170855.html Tamiya mini 4wd 28T brown gear x 2 required https://m.de.aliexpress.com/item/32981057702.html Tamiya mini 4wd pink crown gear x 4 required https://m.de.aliexpress.com/item/1005001815291519.html 620 bearing x 12 required https://m.de.aliexpress.com/item/4001153581706.html 5A dual-way ESC with mixer x 1 required https://m.de.aliexpress.com/item/4000956263121.html 400mah 1S battery x 2 + charger required https://m.de.aliexpress.com/item/1005001859207575.html 1s-powered Transmitter and Receiver set x 1 required https://m.de.aliexpress.com/item/4000063332246.html Battery connector x 2 required (make a y-harness for parallel connection of two 400mah 1S packs for long run-time) https://m.de.aliexpress.com/item/32882903919.html Optional step-up to 5V board if using your own 5v receiver (need to desolder 2 tabs on the board else it steps up to 12v) https://m.de.aliexpress.com/i/4000331025839.html Optional carbon fiber reinforcement plate https://m.de.aliexpress.com/item/4000428875874.html Optional M2 5mm screws for carbon fiber plate mounting https://m.de.aliexpress.com/item/1005002495485705.html